Standard Curved Wheel Sash Pulley - Square End - Antique Brass

• Front plate and wheel are available in 3 different finishes: Polished Brass; Polished Chrome;
Satin Chrome;
• Front plate fits a recess: 25.4mm (w) x 118mm (h) x 3.5mm (d).
• Wheel holder fits a recess central to the front plate: 17mm (w) x 76mm (h) x 39mm (overall depth)
• For use with sash cord only.
• Use with sash cord with the same weight bearing capacity (75Kg) as the pulley.
• Countersunk screw holes for a flush fit.
• It is not necessary to lubricate this pulley wheel before use.
• As a general maintenance guide, it is recommended that after a few years of use, lubricating with a
light oil will help protect, and maintain the life of the wheel.
• Never use a solvent lubricant such as WD40, as this can strip out the grease from the ball bearings

1. Mark the side jamb as close to the top as possible (min 10mm) and central to the sash.
2. Rout out a recess 39mm deep to fit the wheel holder 17mm (w) x 76mm (h).
3. Chisel out a groove to fit the front plate of size: 25.4mm (w) x 118mm (h) x 3.5mm (d) with the
routed recess central to it.
4. Drill a pilot hole for the screws and fix the pulley to the side jamb.
5. Unscrew the pocket at the bottom of the side jamb. Cut the sash cord to the required length and feed
it down through the pulley until it can be pulled out of the bottom of the jamb.
6. Thread the cord through the centre of the lead weight and tie a knot in the end to secure.
7. Feed the cord and lead weight into the side jamb and re-attach the pocket.
8. Fix the sash cord to the routed groove approximately midway down the sash.
9. Repeat this process for the opposite side of the sash, making sure the sash is horizontal.
10. Check that the sash slides freely and adjust as required.